Grinding stone for diamond disc Mechanic ABRASIVE 250x50x25 mm 19568444000

Grinding stone for diamond disc Mechanic ABRASIVE 250x50x25 mm 19568444000

• Width: 50 mm.
• Length: 250 mm.
• Height: 25 mm.
• Compatibility: Diamond disc.
• Packaged in a colored box

Any diamond disc can become dull and lose its cutting properties. This happens especially often when cutting non-abrasive hard, viscous materials such as porcelain stoneware, marble, non-abrasive ceramics, etc. The diamond grains fall out and break down, and the workpiece sticks to the bond surface. The temperature at the point of contact increases, the cutting quality decreases, and the disc stops. There is a risk of damaging your tool. The disc needs to be sharpened. Sharpening means making several cuts on the abrasive material. The MECHANIC ABRASIVE whetstone is perfect for sharpening diamond discs. It has the right combination of size and strength of abrasive grains specially selected for opening the diamond tool. To do this, it is necessary to make several longitudinal cuts with the dull diamond-bearing layer. With an angle grinder disc, we make cuts up to 5 mm deep. With tile cutter discs, up to 10 mm deep. It is recommended to open ceramic discs on the light side of the bar, discs for granite and marble on the dark side. The more blunt the disc, the more cuts need to be made. On average, it is 10-15 cuts and your disc is sharp again. The abrasive bar has a size of 250 * 50 * 25 mm. When cutting on an angle grinder, it is recommended to clamp the bar with a clamp.